Licensed & Insured Independent Pros
You're connected with insured, independent contractors, licensed where required, who handle the full install.
If your Sun Valley basement takes on water at the cove joint, one call connects you with a licensed, insured independent pro who manages that water from inside with a proven drainage system.

Basements go up in separate pours: footing, then walls, then the floor. The seam where the slab meets the wall, called the cove joint, is never truly sealed. It's a cold joint between two separate pours. When groundwater rises around the house, hydrostatic pressure pushes water up through that seam and through the gap between the footing and the slab.
That's the reason seepage so often starts as a dark line along the base of the wall. Sealing the joint from inside rarely works for long, because the pressure behind it doesn't go away. Instead of fighting the water, interior drainage collects it beside the footing and pumps it out before it reaches the floor.
For most existing homes in Sun Valley, it's the most practical full solution. It's installed entirely from inside, works in any season and costs considerably less than excavating around the whole house.

Most failed interior systems failed because of how they were installed, not because the concept doesn't work. The first is a trench that doesn't go deep enough. The drain tile needs to sit beside the footing, not just under the edge of the slab, or water still finds its way up through the cove joint.
The second is cheap backfill. Drain tile should be bedded in washed, clean stone so water flows freely. Dirty gravel or reused soil clogs the pipe over time. Some systems also use a filter fabric sleeve on the pipe to keep fine silt out.
Third is pitch and layout. The drain tile has to slope toward the sump, and a long basement may need more than one sump or a cleanout port for future flushing. Ask the contractor how many access points the system has.
And last, the pump needs to fit the job. An undersized pump runs constantly and burns out early. An oversized one short-cycles. A contractor who sizes the pump to your actual inflow and lift height, and adds a backup, is building a system meant to last.

Interior systems look simple, but the details decide whether they last.
You're connected with insured, independent contractors, licensed where required, who handle the full install.
Written quotes are priced by the linear foot of drain tile, plus the sump package, membrane and any weep holes, with nothing hidden.
Contractors in Sun Valley typically inspect within a day or two, and installs often start within a week or two of approval.
Walk-behind slab saws with water or vacuum dust control, electric jackhammers, HEPA air scrubbers and plastic containment for clean work.
These parts work together as one drainage system.

Perforated pipe is set in clean stone in a trench beside the footing, then covered with fresh concrete, leaving a drainage gap at the wall.
All the drain tile feeds a lidded basin, where a properly sized submersible pump discharges the water outside.
Dimple membrane on the walls guides seepage down into the drain channel and keeps moisture off future framing.
In block foundations, small holes drilled into the bottom of each core let trapped water drain straight into the new system instead of pushing out through the face of the wall.
A battery backup pump and a high-water alarm protect the basement when the power goes out or the main pump fails.
The discharge line exits through the rim joist and runs well away from the foundation. A freeze guard fitting lets water escape if the outside line ices over.
Interior drainage is usually priced by the linear foot of drain tile, so the size of the basement and how many walls need treatment set the baseline. A partial run along one wall can cost a fraction of a full perimeter. Foundation type matters next, since block walls need weep holes and poured walls don't. Obstacles add labor: finished walls that must be opened, stairs, built-in shelves, the furnace and water heater sitting close to the wall.
The sump package changes the price as well. A single pump in a new basin is the baseline, a battery backup and alarm add to it, and a basement with heavy inflow may need two pumps or two pits. Wall membranes, dehumidifiers and electrical work for a dedicated pump circuit are often separate lines. Ask the contractor to mark the drain tile route and sump location on a sketch so you can compare quotes on the same layout.
It's also worth asking what happens to the concrete and debris. Breaking out a perimeter strip produces a surprising amount of rubble, and hauling it away should be included in the quote. So should the final floor patch, dust containment and cleanup. If you plan to finish the basement later, mention it at the start, because the contractor may suggest a wall membrane or a slightly different drain layout that makes finishing easier and protects the new walls from day one.
A clear process, start to finish.
Call +1-866-476-1348 and tell us where and when the water appears and what's along the walls.
A local independent contractor confirms a visit, often within a day or two.
Expect measurements, a proposed layout for drain tile and sump, and a written, itemized quote.
After install, the contractor shows you how to test the pump, what the alarm sounds like and what the warranty covers.
One call connects you with a local independent pro who installs proven interior drainage.
Call +1-866-476-1348We used to get seepage along the floor edge every spring. After drain tile and a sump with backup went in, the floor has stayed dry.
Mike B., Sun Valley
I was dreading the dust, but they set up plastic walls and an air scrubber. Upstairs stayed clean, and they hauled every bit of concrete away.
Linda Q., Sun Valley
Our block walls were always damp. They drilled weep holes, put up a membrane and ran drain tile to a new sump. Now we're finally finishing the basement.
Chris N., Sun Valley
Two-day job, clear quote, no surprises. The contractor showed me how to test the pump and the backup before he left.
Sofia R., Sun Valley
It collects water beside the footing in perforated drain tile, before it reaches the floor, and channels it to a sump pump that discharges it outside. It relieves the pressure that forces water through the cove joint.
There will be a strip of new concrete about a foot wide around the perimeter. In finished basements it's usually hidden under flooring and baseboard. In unfinished spaces it's visible but clean.
Usually the bottom portion of drywall and framing along the affected walls must be removed so the trench can be dug and the membrane installed. If you want to avoid that entirely, ask about exterior waterproofing.
Cutting and breaking concrete is loud, but good contractors contain the dust with sheeting, dust shrouds and air scrubbers. Most families stay home during the work.
Very little. Test the sump pump a couple of times a year, keep the discharge line clear and replace the backup battery as recommended. Some contractors offer annual service checks.
Yes. Partial systems along one or two walls are common when water only enters on one side. The contractor will tell you whether a partial run will do the job or just push water to the next wall.
Calls from across Sun Valley and surrounding communities reach local independent interior drainage pros. Poured, block and stone foundations are all covered.
Local contractors in Sun Valley see every kind of basement, from older block foundations with hollow cores that hold water to newer poured walls that seep only at the cove joint, and they design the drain tile layout and sump location around what they find.
Check the area list below or just call to ask.
