01
Licensed & Insured Independent Pros
Calls go to independent contractors who carry insurance and hold licensing where required, including any electrical work for pump circuits.
Answering Calls Around the Clock
Interior Basement Waterproofing in Argyle, TX
Water seeping in where the wall meets the floor? Call now and we'll connect you with an independent, licensed and insured interior waterproofing contractor in Argyle who installs drain tile, a sump system and wall membranes without digging up your yard.
Call +1-866-476-1348Free referral, day or night
- Interior French drain systems
- Complete sump setups
- Installed from inside, year-round
- Free referral service
- Licensed and insured independent pros
- Written quotes before work
- Open around the clock
The Problem
The Cove Joint Problem
When a basement is built, the footing is poured first, then the walls, then the floor slab. The seam where the slab meets the wall, called the cove joint, is never truly sealed. It's a cold joint between two separate pours. When groundwater rises around the house, hydrostatic pressure pushes water up through that seam and through the gap between the footing and the slab.
That's why so many wet basements show water along the bottom edge of the wall first. Sealing the joint from inside rarely works for long, because the pressure behind it doesn't go away. Instead of fighting the water, interior drainage collects it beside the footing and pumps it out before it reaches the floor.
It's the go-to fix for most existing basements. It's installed entirely from inside, works in any season and costs considerably less than excavating around the whole house.
- Water along the base of the walls after rain
- Seepage up through the slab
- Damp, efflorescent block walls
- Plans to finish the space
Details That Make Interior Drainage Last
Most failed interior systems failed because of how they were installed, not because the concept doesn't work. The first is a trench that doesn't go deep enough. The drain tile needs to sit beside the footing, not just under the edge of the slab, or water still finds its way up through the cove joint.
The second is the wrong stone. Drain tile should be bedded in washed, clean stone so water flows freely. Dirty gravel or reused soil clogs the pipe over time. Some systems also use a filter fabric sleeve on the pipe to keep fine silt out.
Third is pitch and layout. The drain tile has to slope toward the sump, and a long basement may need more than one sump or a cleanout port for future flushing. Ask the contractor how many access points the system has.
And last, the pump needs to fit the job. An undersized pump runs constantly and burns out early. An oversized one short-cycles. A contractor who sizes the pump to your actual inflow and lift height, and adds a backup, is building a system meant to last.
Why Choose Us
Why Argyle Callers Trust Us for Interior Basement Waterproofing
Good interior drainage comes down to careful installation.
02
Upfront Flat-Rate Pricing
Written quotes are priced by the linear foot of drain tile, plus the sump package, membrane and any weep holes, with nothing hidden.
03
Fast Local Dispatch
Contractors in Argyle typically inspect within a day or two, and installs often start within a week or two of approval.
04
Specialized Tools & Equipment
Slab saws with dust control, jackhammers, air scrubbers and containment sheeting keep the mess down.
Solutions
Interior Waterproofing Services in Argyle
Each component handles a specific part of the water problem.
01
Perimeter Drain Tile
A strip of slab around the perimeter is cut and removed, the trench is dug down beside the footing, and perforated pipe is laid in washed stone. New concrete is poured over it, leaving a narrow gap at the wall for drainage.
02
Sump Basin and Pump
The drain tile slopes to a sealed sump basin set below the slab. A submersible pump sized to the expected inflow sends the water out through a discharge line with a check valve.
03
Wall Membranes
A dimpled plastic membrane is fastened to the wall and tucked into the drain channel. Seepage through the wall runs down behind it into the drain tile, and the wall stays dry on the room side.
04
Block Wall Weep Holes
Weep holes at the base of block walls let water trapped in the cores drain into the drain tile.
05
Battery Backup and Alarms
A battery backup pump and a high-water alarm protect the basement when the power goes out or the main pump fails.
06
Discharge Line and Freeze Protection
The discharge line exits through the rim joist and runs well away from the foundation. A freeze guard fitting lets water escape if the outside line ices over.
What Affects the Cost of Interior Waterproofing
Interior drainage is usually priced by the linear foot of drain tile, so the size of the basement and how many walls need treatment set the baseline. A partial run along one wall can cost a fraction of a full perimeter. Foundation type matters next, since block walls need weep holes and poured walls don't. Obstacles add labor: finished walls that must be opened, stairs, built-in shelves, the furnace and water heater sitting close to the wall.
The sump package changes the price as well. A single pump in a new basin is the baseline, a battery backup and alarm add to it, and a basement with heavy inflow may need two pumps or two pits. Wall membranes, dehumidifiers and electrical work for a dedicated pump circuit are often separate lines. Ask the contractor to mark the drain tile route and sump location on a sketch so you can compare quotes on the same layout.
It's also worth asking what happens to the concrete and debris. Breaking out a perimeter strip produces a surprising amount of rubble, and hauling it away should be included in the quote. So should the final floor patch, dust containment and cleanup. If you plan to finish the basement later, mention it at the start, because the contractor may suggest a wall membrane or a slightly different drain layout that makes finishing easier and protects the new walls from day one.
How It Works
From Seepage to a Dry Floor
A clear process, start to finish.
- 1
Call Dispatch
Call +1-866-476-1348 and tell us where and when the water appears and what's along the walls.
- 2
Rapid Mobile Arrival
A nearby contractor sets an inspection time quickly.
- 3
Expert Assessment & Quote
The contractor measures the perimeter, inspects walls and floor, recommends where drain tile and the sump should go and gives you an itemized written quote.
- 4
Resolution & Final Walkthrough
After install, the contractor shows you how to test the pump, what the alarm sounds like and what the warranty covers.
Prep tip: clear about three feet along the walls getting drain tile and cover anything you can't move. The contractor will seal off the work area, but it helps.
Ready for a Dry Basement Floor?
One call connects you with a local independent pro who installs proven interior drainage.
Call +1-866-476-1348Customer Stories
Dry Floors, Finally
Every spring we had a wet line along three walls. They put in drain tile around the whole basement with a sump and battery backup. We made it through the wettest spring in years without a drop.
Mike B., Argyle
They contained the dust with plastic and an air scrubber, and cleaned up completely.
Linda Q., Argyle
Weep holes, membrane and drain tile turned our damp block basement into a space we can finish.
Chris N., Argyle
Done in two days exactly as quoted, plus a quick lesson on testing the pumps.
Sofia R., Argyle
FAQ
Common Interior Basement Waterproofing Questions
How does an interior drainage system work?
Drain tile beside the footing catches water and sends it to a sump pump, which pushes it outside. It relieves the pressure that forces water through the cove joint.
Will the floor look patched afterward?
You'll see a new concrete strip along the edge. In finished basements it's usually hidden under flooring and baseboard. In unfinished spaces it's visible but clean.
Do I need to tear out finished walls?
Typically the lower section of finished walls has to come out. If you want to avoid that entirely, ask about exterior waterproofing.
How loud and messy is the installation?
It's noisy during cutting, but containment keeps dust out of the rest of the house. Most families stay home during the work.
Does an interior system need maintenance?
Minimal. Test the pumps twice a year and keep the discharge outlet clear. Some contractors offer annual service checks.
Can I add interior drainage to just one wall?
Yes. Partial systems along one or two walls are common when water only enters on one side. The contractor will tell you whether a partial run will do the job or just push water to the next wall.
Service Area
Interior Basement Waterproofing Coverage In and Around Argyle
Calls from across Argyle and surrounding communities reach local independent interior drainage pros. Poured, block and stone foundations are all covered.
Local contractors in Argyle see every kind of basement, from older block foundations with hollow cores that hold water to newer poured walls that seep only at the cove joint, and they design the drain tile layout and sump location around what they find.
Check the area list below or just call to ask.
