01
Licensed & Insured Independent Pros
Calls go to independent contractors carrying liability coverage and licensing where required, including those who work with builders on new construction.
24/7 Foundation Water Line
Foundation Waterproofing in Savannah, TX
Foundation walls wicking moisture, weeping at tie-rod holes or showing efflorescence? Call now and we'll connect you with an independent, licensed and insured contractor in Savannah who seals foundations below grade, for new builds and existing homes.
Call +1-866-476-1348Free referral, day or night
- Membranes rated for real water pressure
- New builds and existing homes
- Upfront written quotes
- No-cost referral
- Licensed and insured independent pros
- Upfront written pricing
- Phones answered 24/7
The Problem
Damp-Proofing Isn't Waterproofing
Many builders apply only a thin asphalt damp-proofing coat, which code allows but which doesn't stop water under pressure. Damp-proofing slows vapor. It doesn't bridge cracks, and it breaks down over time in wet soil. Once the soil around the house saturates, water pushes through shrinkage cracks, tie-rod holes, form joints and pipe penetrations.
Concrete block is even more vulnerable. The mortar joints and hollow cores soak up moisture, which shows up as white efflorescence, peeling paint and a constant damp feel. Foundation waterproofing treats the wall itself as the barrier, using membranes, sealants and drainage layers designed to hold back water, not just vapor.
For new homes, it's far cheaper to do it right before backfill. For existing homes, contractors can excavate and retrofit, or combine targeted exterior work with interior drainage.
- Leaks at tie-rod holes and form joints
- Water around pipe entries
- White staining and wet block
- New builds before backfill
Choosing the Right Membrane for the Site
Not every foundation faces the same water. A house on sandy, well-drained soil with a low water table needs good protection and a working footing drain, but it isn't fighting constant pressure. A house on dense clay, a low lot or a site with a seasonal high water table has water sitting against the wall for weeks. That second house needs a heavier membrane, a drainage board with real flow capacity and a footing drain that can keep up.
Fluid-applied membranes are the most common choice for residential work. They go on seamless, wrap around tie-rods and penetrations, and bridge hairline cracks. The key quality check is thickness: the crew should measure wet film thickness as they go, because a membrane applied too thin won't perform as rated.
Sheet membranes and bentonite systems show up more on commercial jobs and difficult sites. Sheets give a consistent factory thickness, which helps on large wall areas. Bentonite swells when it gets wet and seals small gaps on its own, though it needs to be confined by backfill to work properly.
No membrane works well without drainage. Drainage board and a footing drain take the pressure off, so the membrane only has to deal with water that's already moving away. Skipping drainage to save money is one of the most common reasons foundation waterproofing fails early.
What drives the price is mostly how hard the wall is to reach. On new construction, with the walls already exposed, you're paying for materials and application. On an existing home, excavation, hauling, shoring for deep trenches and restoring landscaping usually make up the larger share of the bill. A contractor should break those pieces out separately so you can see where the money goes, and so you can compare a full-perimeter job against sealing only the walls that actually leak.
Why Choose Us
Why Homeowners Call Us for Foundation Waterproofing in Savannah, TX
Getting the materials and the prep right is what makes it last.
02
Upfront Flat-Rate Pricing
Pricing is written by wall section or linear foot, with membrane type, drainage board and footing drain called out separately.
03
Fast Local Dispatch
Builders on a schedule and homeowners with active seepage both get quick scheduling from contractors who work in Savannah.
04
Specialized Tools & Equipment
Airless spray rigs for fluid-applied membranes, wet film thickness gauges, pressure-wash surface prep and low-pressure injection kits for penetrations.
Solutions
What Proper Foundation Waterproofing Includes
A complete job layers protection so water has no easy path through.
01
Spray-Applied Waterproofing Membranes
A thick, seamless rubberized asphalt or polymer membrane is sprayed or rolled onto the cleaned wall at a specified mil thickness. It stretches to bridge small cracks that would split ordinary damp-proofing.
02
Self-Adhered Sheets and Bentonite Panels
Self-adhering sheet membranes give a consistent factory thickness, and bentonite clay panels swell when wet to seal themselves. Both are common on commercial foundations and high water table sites.
03
Drainage Board Protection
A dimpled drainage board over the membrane protects it from rocks during backfill and gives water a free path down to the footing drain, relieving pressure on the wall.
04
Perimeter Footing Drains
A gravel-bedded, filter-wrapped drain at the footing carries water away so the membrane isn't holding back a saturated trench.
05
Tie-Rod and Penetration Sealing
Snap-tie holes and utility penetrations get injected or sealed with flexible materials that move with the wall.
06
Block Foundation Treatments
Block walls are often parged with a cementitious coat before membrane application to fill mortar joints and create a smooth surface for proper adhesion.
Why Some Foundation Waterproofing Fails Early
Most foundation waterproofing failures trace back to a handful of shortcuts. The first is skipping surface prep. A membrane applied over dirt, loose parging or form release oil won't bond, and water gets behind it within a few seasons. The second is applying it too thin. Fluid membranes are rated at a specific thickness, and a crew in a hurry can easily put on half that.
The third is leaving out the drainage board, which lets sharp backfill puncture the membrane and leaves water pressing against the wall instead of draining down. The fourth is a footing drain with no outlet, or one that discharges into a spot that floods. The last is backfilling with the same clay that came out of the hole, which holds water against the wall. A contractor who explains how they avoid each of these is one who has seen what happens when they're ignored.
On an existing home, ask the contractor how they'll protect the membrane during backfill, where the footing drain will discharge and how the final grade will slope. Those three answers tell you more about the quality of the job than the brand name on the membrane bucket.
How It Works
How a Foundation Waterproofing Call Works
Whether it's a new build or a retrofit, the steps are straightforward.
- 1
Call Dispatch
Call +1-866-476-1348 and describe the foundation type, the moisture and your timeline.
- 2
Rapid Mobile Arrival
A nearby contractor confirms a visit, working around construction schedules when needed.
- 3
Expert Assessment & Quote
Expect a wall inspection, a system recommendation suited to the site and an itemized written quote.
- 4
Resolution & Final Walkthrough
The wall is prepped and sealed, drainage board and footing drain go in, and the contractor documents the work before backfill and reviews the warranty with you.
Building new? Ask for photos of the membrane and drainage board before backfill. Once the trench is filled, nobody can check the work again.
Seal Your Foundation the Right Way
Call now for a free referral to a licensed, insured independent foundation waterproofing contractor in Savannah.
Call +1-866-476-1348Customer Stories
What Savannah Homeowners and Builders Say
Our builder planned on damp-proofing only. We upgraded to a membrane and drainage board, and the basement has stayed dry since day one.
Jordan P., Savannah
Three snap-tie holes leaked every storm. They were injected in an afternoon and haven't leaked since.
Mei L., Savannah
Our old block foundation was always damp and chalky. They excavated one side, parged it, put on a membrane and new footing drain. Night and day difference.
Carl B., Savannah
Clear quote, showed up when promised and sent pre-backfill photos without me even asking.
Ana V., Savannah
FAQ
Common Foundation Waterproofing Questions
What's the difference between damp-proofing and waterproofing?
Damp-proofing resists moisture vapor only. Waterproofing uses thicker, flexible membranes designed to stop liquid water under hydrostatic pressure.
Can an existing foundation be waterproofed from the outside?
Yes. The contractor excavates to the footing, cleans and repairs the wall, then applies a membrane, drainage board and footing drain before backfilling. It's more involved than interior work but stops water at the source.
How long does a foundation membrane last?
Properly installed and protected membranes are built to last for many years. Ask the contractor for the manufacturer's rated lifespan and the written warranty terms.
Is foundation waterproofing worth it on new construction?
It's the cheapest moment to do it. The walls are already exposed, so you're paying for materials and labor, not excavation. Retrofitting later costs far more.
Can tie-rod leaks be fixed without digging?
Usually, yes. Tie-rod holes and small penetrations are often sealed from inside with injection. If many points leak, a broader solution may be more cost-effective.
Does foundation waterproofing require a permit?
Requirements vary locally. Excavation, drainage tie-ins and structural repairs are the most likely to need one, so ask the contractor who handles it.
Service Area
Foundation Waterproofing Coverage In and Around Savannah
Calls from all over Savannah and nearby areas reach local independent contractors who seal foundations below grade. That covers new construction, additions and existing homes.
Check the list below or call to ask about your area.
